Lexus IS250 · Service Manual TRANSMISSION

REMOVAL

Removal / installation


1. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.

(Click here)

3. REMOVE LOWER NO. 2 STEERING WHEEL COVER

  1. C122398
    Using a screwdriver, remove the steering wheel No.2 cover lower.

    HINT:
    Tape up the screwdriver tip before use.


4. REMOVE LOWER NO. 3 STEERING WHEEL COVER

  1. C122397
    Using a screwdriver, remove the steering wheel No.3 cover lower.

    HINT:
    Tape up the screwdriver tip before use.


5. REMOVE STEERING PAD

  1. C122396E01
    Using a "torx" socket wrench (T30), loosen the 2 "torx" screws until the groove along the screw circumference catches on the screw case.

  1. C122394
    Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Disconnect the horn connector.

  1. Disconnect the 2 connectors from the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Remove the steering pad.


6. REMOVE STEERING WHEEL ASSEMBLY

  1. C115542E01
    Remove the steering wheel assembly set nut.

  1. Put matchmarks on the steering wheel assembly and main shaft assembly.

  1. Using SST, remove the steering wheel assembly.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05011)


7. REMOVE SHIFT PADDLE SWITCH

  1. C125811E01
    Disconnect the clamp from the steering wheel assembly.

  1. Disconnect the switch wire connector from the steering wheel assembly.

  1. C125812E01
    Disconnect the 2 connectors from the 2 shift paddle switches, and remove the switch wire.

  1. C125813E01
    Remove the 4 screws, 2 brackets and 2 shift paddle switches.

← COMPONENTSINSPECTION →