Lexus IS250 · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation


1. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

  1. B124501
    Using a screwdriver wrapped with protective tape, disengage the 3 claws and remove the rear door inside handle bezel plug.


2. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY

  1. B124502
    Using a screwdriver wrapped with protective tape, disengage the 2 claws and 2 clips.

  1. Disconnect the connector and remove the rear power window regulator switch assembly.


3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

  1. B124503
    Remove the 2 screws.

  1. Using the clip remover, disengage the 8 clips.

  1. B127039E01
    Pull out the rear door trim board in the direction indicated by the arrow.

  1. Remove the reference bosses from the rear door panel.

  1. Raise the rear door trim board to disengage the 3 claws and remove the rear door trim board together with the rear door inner glass weatherstrip.

  1. B124505
    Disconnect the cables and each connector from the back side of the inside handle and the rear door trim board sub-assembly, remove the rear door trim board sub-assembly.

  1. Remove the 2 rear door trim board retainers (green) from the rear door trim board.


4. REMOVE REAR DOOR TRIM COVER

  1. B124509
    Remove the screw.

  1. Using a clip remover, detach the 5 clips and remove the rear door trim cover.


5. REMOVE REAR DOOR SERVICE HOLE COVER

  1. B124511
    Disconnect the connector and 2 clamps.

  1. Remove the rear door service hole cover.

    HINT:
    Remove the remaining tape on the door side.


6. REMOVE REAR DOOR GLASS RUN

  1. B124515
    Remove the rear door glass run.


7. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

  1. B124516
    Remove the 2 bolts, the screw, and the rear door window division bar sub-assembly.


8. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

  1. B124518
    Remove the rear door glass sub-assembly from the rear door window regulator sub-assembly as shown in the illustration.

    NOTICE:
    Do not damage the door glass.


9. REMOVE REAR DOOR LOCK ASSEMBLY

  1. B124521
    Using a "torx" socket wrench (T30), remove the 3 screws and the rear door lock assembly.

  1. Move the rear door lock assembly downward and pull the release plate out of the rear door outside handle frame.

  1. Remove the door lock wiring harness seal from the rear door lock assembly.

  1. B124522
    Using a screwdriver, disengage the claw.

  1. B129032
    Remove the rear door lock remote control cable assembly.

  1. B124524
    Using a screwdriver, disengage the 3 claws.

  1. B124535
    Remove the rear door inside locking cable assembly.

← COMPONENTSINSPECTION →