Lexus IS250 · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation


1. REMOVE REAR SEAT CUSHION ASSEMBLY

  1. B121659E01
    Detach the 2 front hooks of the seat cushion from the vehicle body.

    NOTICE:
    Follow the instructions below carefully as the cushion frame deforms easily.


    1. Choose a hook to detach first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to detach the hook.

    2. Repeat for the other hook.

  1. Detach the 2 rear hooks of the seat cushion from the seatback.

  1. Remove the seat cushion.


2. REMOVE REAR SEAT HEADREST ASSEMBLY

3. REMOVE REAR CENTER SEAT HEADREST ASSEMBLY

4. REMOVE REAR SEATBACK ASSEMBLY

  1. B105996E02
    Using a screwdriver, detach the claws to open the cap of the 3 rear seat shoulder belt guides.

  1. B120546E02
    Using a screwdriver, detach the claw to open the cap of the 3 rear seat shoulder belt guides.

  1. B121660
    Remove the 4 bolts and rear seatback assembly.


5. REMOVE REAR DOOR SCUFF PLATE LH

  1. B125386E01
    Put protective tape around the rear door scuff plate.

  1. Using a moulding remover, disengage the 2 clips.

  1. B125387
    Disengage the 5 claws and remove the the rear door scuff plate LH.


6. REMOVE REAR DOOR SCUFF PLATE RH

7. REMOVE REAR SIDE SEAT GARNISH LH

  1. B125408
    Disengage the 5 claws and remove the rear seat side garnish LH.


8. REMOVE REAR SIDE SEAT GARNISH RH

9. REMOVE ROOF SIDE INNER GARNISH LH

  1. B125407
    Disengage the 4 clips and claw, and remove the roof side inner garnish LH.


10. REMOVE ROOF SIDE INNER GARNISH RH

11. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY

  1. B122791
    Remove the bolt and separate the floor side of the rear seat 3 point type belt assembly LH.

    HINT:
    Use the same procedures for the RH side and the LH side.

  1. B119437
    Remove the bolt and separate the floor side of the rear seat inner with center belt assembly RH.

  1. B126802
    Disengage the 3 clips and raise the front portion of the package tray trim panel assembly.

  1. B126803
    Disengage the 2 claws and remove the rear seat shoulder belt covers.

    HINT:
    Use the same procedure for the other 2 rear seat shoulder belt covers.

  1. Pass the 3 rear seat belt floor anchors through the holes in the package tray trim panel assembly.

  1. Remove the package tray trim panel assembly.


12. REMOVE STEREO COMPONENT SPEAKER ASSEMBLY

  1. E117361E01
    Disconnect the connector.

  1. Remove the 4 bolts and stereo component speaker assembly.

    NOTICE:
    Do not touch the cone part of the speaker.


13. REMOVE NO. 2 PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Front Center Speaker)

  1. B126804
    Disengage the 3 clips and 5 claws, and remove the No. 2 package tray trim panel assembly.


14. REMOVE REAR STEREO COMPONENT SPEAKER ASSEMBLY (w/ Front Center Speaker)

  1. E119008
    Disconnect the connector.

  1. Remove the bolt.

  1. Disengage the clip and remove the rear stereo component speaker assembly.

    NOTICE:
    Do not touch the cone part of the speaker.

← ON-VEHICLE INSPECTIONINSTALLATION →