Lexus IS250 · Service Manual BODY ELECTRICAL

INSPECTION

Inspection


INSPECT SATELLITE SWITCH

  1. E118881E02
    Disconnect the connector from the satellite switch.

  1. Measure the resistance between the terminals according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    		 Condition
    		 Specified Condition
    J16-2 (LSET) - J16-5 (E)
    		 Integration switch LH is pressed
    		 Below 1 Ω
    J16-2 (LSET) - J16-5 (E)
    		 Integration switch LH is not pressed
    		 10 kΩ or higher
    J16-3 (SET) - J16-5 (E)
    		 Integration switch ON/OFF is pressed
    		 Below 1 Ω
    J16-3 (SET) - J16-5 (E)
    		 Integration switch ON/OFF is not pressed
    		 10 kΩ or higher
    J16-4 (RSEL) - J16-5 (E)
    		 Integration switch RH is pressed
    		 Below 1 Ω
    J16-4 (RSEL) - J16-5 (E)
    		 Integration switch RH is not pressed
    		 10 kΩ or higher

    HINT:
    If the value is not as specified, replace the satellite switch.

← REMOVALINSTALLATION →