INSTALLATION
Removal / installation
| 1. INSTALL DISCHARGE HEADLIGHT BULB |
Install the discharge headlight bulb.
- NOTICE:
- After the discharge headlight bulb is replaced, make sure that it comes on. Then, reinstall all the parts that were removed to replace the bulb.
Install a new headlight gasket.
- NOTICE:
- After the headlight gasket is removed, be sure to replace it with a new one. Failure to do this may cause water ingress.
| 2. INSTALL WASHER HOSE |
Install the washer hose with the bolt.
- Torque:
- 5.5 N*m{ 56 kgf*cm , 49 in.*lbf }
| 3. INSTALL ENGINE ROOM SIDE COVER |
Install the engine room side cover with the nut.
Install the 4 clips.
| 4. INSTALL COOL AIR INTAKE DUCT SEAL |
| 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 6. PERFORM INITIALIZATION |