Integration Control and Panel Assembly Power Source Circuit

DESCRIPTION

This is the power source circuit to operate the integration control & panel assembly.

WIRING DIAGRAM

INSPECTION PROCEDURE

1. INSPECT INTEGRATION CONTROL & PANEL ASSEMBLY

1. Disconnect the integration control & panel assembly connector J54.

2. Measure the resistance according to the value(s) in the table below.

   Standard resistance:

   Tester connection	Condition	Specified condition
   E - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard voltage:

   Tester connection	Condition	Specified condition
   B - GND	Always	10 to 14 V
   ACC - GND	Engine SW on (ACC)	10 to 14 V
   IG+ - GND	Engine SW on (IG)	10 to 14 V

NG	REPAIR OR REPLACE HARNESS OR CONNECTOR

OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE