B2232

DESCRIPTION

The No. 1 ultrasonic sensor (front left sensor) is installed on the front bumper.
The clearance warning ECU detects obstacles based on signals received from the front left sensor. If the front left sensor's circuit has an open, short or other malfunction, it will not function normally.

DTC No.	DTC Detection Condition	Trouble Area
B2232	Malfunction of No. 1 ultrasonic sensor (Front left sensor)	No. 1 ultrasonic sensor Wire harness Clearance warning ECU

WIRING DIAGRAM

INSPECTION PROCEDURE

1. INSPECT NO. 1 ULTRASONIC SENSOR

1. Remove the ultrasonic sensor.

2. Measure the resistance of the sensor.

   Standard resistance:

   Tester Connection	Condition	Specified Condition
   S (D2-2) - E (D2-1)	Always	600 to 1,200 kΩ

   NOTICE:

   Set the tester to the 100 kΩ range before performing the measurement.

NG	REPLACE NO. 1 ULTRASONIC SENSOR (FRONT LEFT SENSOR)

OK

2. CHECK WIRE HARNESS (CLEARANCE WARNING ECU - ULTRASONIC SENSOR)

1. Disconnect the Q37 ECU connector.

2. Disconnect the D2 sensor connector.

3. Measure the resistance of the wire harness side connectors.

   Standard resistance:

   Tester Connection	Condition	Specified Condition
   S4 (Q37-6) - S (D2-2)	Always	Below 1 Ω
   E4 (Q37-19) - E (D2-1)	Always	Below 1 Ω
   S4 (Q37-6) - Body ground	Always	10 kΩ or higher
   E4 (Q37-19) - Body ground	Always	10 kΩ or higher

NG	REPAIR OR REPLACE HARNESS OR CONNECTOR

OK
REPLACE CLEARANCE WARNING ECU