СИСТЕМА SFI > Цепь функции полуавтоматического запуска двигателя

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

CHECK OPERATION OF CRANKING

CHECK SMART ACCESS SYSTEM WITH PUSH-BUTTON START (ENGINE DOES NOT START)

READ VALUE OF INTELLIGENT TESTER (STARTER SIGNAL)

INSPECT ECM (STAR AND STSW VOLTAGE)

INSPECT ST CUT RELAY

INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY

CHECK HARNESS AND CONNECTOR (ST CUT RELAY - PARK/NEUTRAL POSITION SWITCH, ECM)

CHECK ENGINE ROOM NO. 2 RELAY BLOCK (ST CUT RELAY - IG2 RELAY, BODY GROUND)

INSPECT STARTER RELAY

CHECK HARNESS AND CONNECTOR (ST RELAY - PARK/NEUTRAL POSITION SWITCH, BODY GROUND)

INSPECT STARTER ASSEMBLY

CHECK HARNESS AND CONNECTOR (STARTER ASSEMBLY - ST RELAY, BATTERY)