РАСПРЕДВАЛ (для ряда 1) > СНЯТИЕ

1. DISCHARGE FUEL SYSTEM PRESSURE

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

3. REMOVE TIMING CHAIN COVER SUB-ASSEMBLY

4. SET NO. 1 CYLINDER TO TDC / COMPRESSION

5. REMOVE NO. 1 CHAIN TENSIONER ASSEMBLY (for Bank 1)

6. REMOVE CHAIN TENSIONER SLIPPER (for Bank 1)

7. REMOVE NO. 1 CHAIN VIBRATION DAMPER (for Bank 1)

8. REMOVE CHAIN SUB-ASSEMBLY (for Bank 1)

9. REMOVE NO. 3 CHAIN TENSIONER ASSEMBLY

10. REMOVE CAMSHAFT BEARING CAP (for Bank 1)

11. REMOVE CAMSHAFT HOUSING SUB-ASSEMBLY (for Bank 1)