DTC    P1364    "C" Camshaft Position Actuator Circuit Open, Low, High Bank1

DESCRIPTION

MONITOR DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

INSPECT VVT LH RELAY OR VVT RH RELAY

CHECK HARNESS AND CONNECTOR (POWER SOURCE VOLTAGE)

CHECK HARNESS AND CONNECTOR

CHECK HARNESS AND CONNECTOR (CAMSHAFT TIMING CONTROL MOTOR - ECM)

REPLACE CAMSHAFT TIMING CONTROL MOTOR (BANK 1 OR BANK 2)

INSPECT CAMSHAFT TIMING CONTROL MOTOR (BANK 1 OR BANK 2)

REPAIR OR REPLACE HARNESS OR CONNECTOR (CAMSHAFT TIMING CONTROL MOTOR - VVT LH OR VVT RH RELAY)

CHECK WHETHER DTC OUTPUT RECURS