| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Brake | Section: Brake Control/Dynamic Control System | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000000SS5015X |
| Title: BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: YAW RATE AND DECELERATION SENSOR: REMOVAL (2008 LX570) | ||
REMOVAL
1. REMOVE ENGINE ROOM SIDE COVER LH (w/ Cool Box)
2. REMOVE ENGINE ROOM SIDE COVER RH (w/ Cool Box)
3. REMOVE UPPER RADIATOR SUPPORT SEAL (w/ Cool Box)
4. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM (w/ Cool Box)
5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
-
w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
6. REMOVE FRONT SEAT ASSEMBLY LH (w/ Cool Box)
(a) Remove the front seat assembly LH
.
7. REMOVE REAR CONSOLE BOX SUB-ASSEMBLY (w/o Cool Box)
(a) Remove the rear console box sub-assembly
.
8. REMOVE COOLING BOX ASSEMBLY (w/ Cool Box)
(a) Remove the cooling box assembly
.
9. REMOVE YAW RATE SENSOR
(a) Remove the 2 bolts and sensor.
(b) Disconnect the sensor connector and then detach the clamp from the sensor bracket.
|
|