| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Vehicle Interior | Section: Interior Panels/Trim | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM0000039QF002X |
| Title: INTERIOR PANELS / TRIM: FRONT CONSOLE BOX (w/o Cool Box): REMOVAL (2008 LX570) | ||
REMOVAL
1. REMOVE ENGINE ROOM SIDE COVER LH (w/ LEXUS Link System)
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ LEXUS Link System)
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
-
w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
3. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
|
(a) Detach the 8 claws. |
(b) Disconnect the connector and remove the panel pad.
4. REMOVE INNER NO. 1 INSTRUMENT PANEL BRACKET COVER LH
|
(a) Remove the clip. |
(b) Detach the clip and remove the cover.
5. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH
|
(a) Detach the 9 claws and remove the panel pad. |
6. REMOVE INNER NO. 1 INSTRUMENT PANEL BRACKET COVER RH
|
(a) Detach the clip and remove the cover. |
7. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
|
(a) Twist the shift lever knob in the direction indicated by the arrow and remove it. |
8. REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
|
(a) Detach the 8 claws. |
(b) Disconnect the connectors and remove the panel.
9. REMOVE PARKING BRAKE HOLE COVER
|
(a) Detach the 6 claws and remove the cover. |
10. REMOVE CONSOLE CUP HOLDER BOX SUB-ASSEMBLY
|
(a) Detach the 4 claws and remove the box. |
11. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
|
(a) Detach the 13 claws. |
(b) Disconnect the connectors and remove the console panel.
12. REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY
(a) Place protective tape as shown in the illustration.
(b) Using a moulding remover, detach the 6 claws.
(c) Remove the end panel and disconnect the connectors and 3 clamps.
13. REMOVE TELEPHONE ECU ASSEMBLY WITH BRACKET (w/ LEXUS Link System)
14. REMOVE REAR CONSOLE BOX SUB-ASSEMBLY
(a) Remove the 4 bolts and 2 screws.
(b) Detach the 2 claws and remove the console box.
|
|