| Last Modified: 11-27-2007 | 1.6 D | |
| Service Category: Vehicle Interior | Section: Supplemental Restraint Systems | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000000VVF010X |
| Title: PRE-COLLISION: PRE-COLLISION SYSTEM: HOW TO PROCEED WITH TROUBLESHOOTING (2008 LX570) | ||
HOW TO PROCEED WITH TROUBLESHOOTING
HINT:
- Use these procedures to troubleshoot the pre-collision system.
- *: Use the Techstream.
|
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
|
2. |
INSPECT BATTERY VOLTAGE |
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
|
|
3. |
CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
(a) Use the Techstream to check if the CAN communication system is functioning normally
.
Result
|
Result |
Proceed to |
|---|---|
|
CAN DTC is not output |
A |
|
CAN DTC is output |
B |
| B |
|
GO TO CAN COMMUNICATION SYSTEM |
|
|
4. |
CHECK INDICATOR |
(a) Check the indicator
.
|
|
5. |
CHECK FOR DTC* |
(a) Check for DTCs
.
(b) Clear the DTCs
.
(c) Recheck for DTCs
.
Result
|
Result |
Proceed to |
|---|---|
|
DTC is not output |
A |
|
DTC is output |
B |
| B |
|
GO TO DTC CHART |
|
|
6. |
PROBLEM SYMPTOMS TABLE |
(a) Refer to the Problem Symptoms Table
.
Result
|
Result |
Proceed to |
|---|---|
|
Fault is not listed in problem symptoms table |
A |
|
Fault is listed in problem symptoms table |
B |
| B |
|
Go to step 8 |
|
|
7. |
OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Terminals of ECU
.
(b) Data List / Active Test
.
|
|
8. |
ADJUST, REPAIR OR REPLACE |
|
|
9. |
CONFIRMATION TEST |
| NEXT |
|
END |
|
|