| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Drivetrain | Section: Axle/Differential | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM0000017BL00OX |
| Title: AXLE AND DIFFERENTIAL: FRONT DIFFERENTIAL CARRIER ASSEMBLY: INSTALLATION (2008 LX570) | ||
INSTALLATION
1. INSTALL FRONT DIFFERENTIAL CARRIER ASSEMBLY
|
(a) Install the differential support assembly with bolts E and F. Torque: 100 N·m (1020 kgf·cm, 74 ft·lbf) |
(b) Using a jack, slowly raise the front differential carrier assembly to its installation position.
(c) Temporarily install the front differential support assembly with bolts A and B and the nut.
(d) Temporarily install the bolts C and D.
(e) Tighten bolt A.
Torque: 120 N·m (1224 kgf·cm, 89 ft·lbf)
(f) Tighten bolt B and the nut.
Torque: 120 N·m (1224 kgf·cm, 89 ft·lbf)
(g) Tighten bolts C and D.
Torque: 120 N·m (1224 kgf·cm, 89 ft·lbf)
(h) Connect the breather tube to the front differential union.
2. INSTALL FRONT SUSPENSION REBOUND STOPPER SUB-ASSEMBLY LH
|
(a) Install the suspension rebound stopper LH with 3 bolts. Torque: 58 N·m (591 kgf·cm, 43 ft·lbf) |
3. INSTALL FRONT SUSPENSION REBOUND STOPPER SUB-ASSEMBLY RH
|
(a) Install the suspension rebound stopper RH with 3 bolts. Torque: 58 N·m (591 kgf·cm, 43 ft·lbf) |
4. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
(a) Install the front drive shaft
.
5. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH
HINT:
Use the same procedure as the LH side.
6. INSTALL FRONT PROPELLER SHAFT ASSEMBLY
(a) Install the front propeller shaft
.
|
|