Home › Vehicle Interior › Heating/Air Conditioning › COMPRESSOR
Last Modified: 11-27-2007 1.6 A
Service Category: Vehicle Interior Section: Heating/Air Conditioning
Model Year: 2008 Model: LX570 Doc ID: RM000001801017X
Title: HEATING / AIR CONDITIONING: COMPRESSOR: REMOVAL (2008 LX570)

REMOVAL

1. REMOVE ENGINE ROOM SIDE COVER LH EXTERIOR PANELS / TRIM: RADIATOR GRILLE: REMOVAL (2008 LX570)+

2. REMOVE ENGINE ROOM SIDE COVER RH EXTERIOR PANELS / TRIM: RADIATOR GRILLE: REMOVAL (2008 LX570)+

3. REMOVE UPPER RADIATOR SUPPORT SEAL EXTERIOR PANELS / TRIM: RADIATOR GRILLE: REMOVAL (2008 LX570)+

4. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM HEATING / AIR CONDITIONING: REFRIGERANT: REPLACEMENT (2008 LX570)+

5. REMOVE FRONT FENDER APRON SEAL LH



(a) Remove the 4 clips and seal.

6. REMOVE FAN AND GENERATOR V BELT 3UR-FE ENGINE MECHANICAL: DRIVE BELT: REMOVAL (2008 LX570)+

7. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

(a) Remove the bolt and disconnect the discharge hose from the cooler compressor.

(b) Remove the O-ring from the discharge hose.

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

8. DISCONNECT SUCTION HOSE SUB-ASSEMBLY

(a) Remove the bolt and disconnect the suction hose from the cooler compressor.

(b) Remove the O-ring from the suction hose.

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

9. REMOVE COOLER COMPRESSOR ASSEMBLY

(a) Disconnect the connector.

(b) Remove the 3 bolts and nut.

(c) Remove the stud bolt and cooler compressor.