- Harness or connector
- Navigation antenna assembly
- Display and navigation module display
| Last Modified: 11-27-2007 | 1.6 C | |
| Service Category: Audio/Visual/Telematics | Section: Navigation/Multi Info Display | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM00000182T02RX |
| Title: NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: DESCRIPTION (2008 LX570) | ||
|
DTC |
58-40 |
GPS Antenna Error |
|
DTC |
58-41 |
GPS Antenna Power Source Error |
|
DTC |
80-40 |
GPS Antenna Error |
|
DTC |
80-41 |
GPS Antenna Power Source Error |
DESCRIPTION
|
DTC Code |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
58-40 |
A navigation antenna error. |
|
|
58-41 |
An error of the power source to the navigation antenna. |
|
|
80-40 |
A navigation antenna error. |
|
|
80-41 |
An error of the power source to the navigation antenna. |
INSPECTION PROCEDURE
HINT:
After the inspection is completed, clear the DTCs
.
PROCEDURE
|
1. |
CHECK HARNESS AND CONNECTOR (NAVIGATION ANTENNA - DISPLAY AND NAVIGATION MODULE DISPLAY) |
(a) Check if the navigation antenna cord is securely connected to the display and navigation module display.
OK:
The cord is securely connected.
|
|
2. |
INSPECT NAVIGATION ANTENNA |
|
(a) Disconnect the navigation antenna connector. |
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
1 - Shielded |
Always |
50 to 500 Ω |
|
|
3. |
CLEAR AND RECHECK DTC |
(a) Clear the DTCs
.
(b) Recheck for DTCs and check if the same trouble code is output.
OK:
No DTC is output.
|
|
|