Home › Brake › Brake System › BRAKE SYSTEM (OTHER): BRAKE PEDAL
Last Modified: 11-27-2007 1.6 A
Service Category: Brake Section: Brake System
Model Year: 2008 Model: LX570 Doc ID: RM000001Q8I00HX
Title: BRAKE SYSTEM (OTHER): BRAKE PEDAL: REMOVAL (2008 LX570)

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION (2008 LX570) .

2. REMOVE FRONT DOOR SCUFF PLATE LH INTERIOR PANELS / TRIM: ROOF HEADLINING: REMOVAL (2008 LX570)+

3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY INTERIOR PANELS / TRIM: INSTRUMENT PANEL SAFETY PAD: REMOVAL (2008 LX570)+

4. REMOVE COWL SIDE TRIM BOARD LH INTERIOR PANELS / TRIM: INSTRUMENT PANEL SAFETY PAD: REMOVAL (2008 LX570)+

5. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL INTERIOR PANELS / TRIM: INSTRUMENT PANEL SAFETY PAD: REMOVAL (2008 LX570)+

6. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY SUPPLEMENTAL RESTRAINT SYSTEMS: KNEE AIRBAG ASSEMBLY (for Driver Side): REMOVAL (2008 LX570)+

7. REMOVE PUSH ROD PIN

(a) Remove the clip and push rod pin from the brake pedal lever.

8. REMOVE STOP LIGHT SWITCH ASSEMBLY

(a) Disconnect the stop light switch connector.

(b) Remove the stop light switch LIGHTING (EXT): STOP LIGHT SWITCH: REMOVAL (2008 LX570)+ .

9. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY

(a) Remove the brake pedal support reinforcement set bolt.

(b) Remove the 4 nuts and brake pedal support assembly.