3UR-FE ENGINE MECHANICAL: REAR CRANKSHAFT OIL SEAL: REMOVAL (2008 LX570)

Home › Engine/Hybrid System › Engine Mechanical › 3UR-FE ENGINE MECHANICAL: REAR CRANKSHAFT OIL SEAL

Last Modified: 11-27-2007		1.6 A
Service Category: Engine/Hybrid System	Section: Engine Mechanical
Model Year: 2008	Model: LX570	Doc ID: RM000002BRK00FX
Title: 3UR-FE ENGINE MECHANICAL: REAR CRANKSHAFT OIL SEAL: REMOVAL (2008 LX570)

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

w/ Navigation System:

After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

When disconnecting the cable, some systems need to be initialized after the cable is reconnected .

2. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY

(a) Remove the automatic transmission .

3. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

4. REMOVE REAR CRANKSHAFT OIL SEAL

(a) Using a knife, cut off the lip of the oil seal.

(b) Using a screwdriver, pry out the oil seal.

HINT:

Tape the screwdriver tip before use.

NOTICE:

Do not damage the surface of the oil seal press fit hole and crankshaft.