| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Suspension | Section: Tire Pressure Monitoring | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000002L8L006X |
| Title: TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING ECU: REMOVAL (2008 LX570) | ||
REMOVAL
NOTICE:
- When replacing the tire pressure warning ECU, read the IDs stored in the old ECU using the Techstream and write them down before removal.
-
It is necessary to perform initialization
after registration
of the transmitter IDs into the tire pressure warning ECU after the ECU and/or a valve and transmitter has been replaced.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
w/ Navigation System:
NOTICE:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
2. REMOVE REAR NO. 2 SEAT ASSEMBLY
(a) for Power Seat:
Remove the rear No. 2 seat
.
(b) for Manual Seat:
Remove the rear No. 2 seat
.
3. REMOVE REAR STEP COVER
4. REMOVE REAR DOOR SCUFF PLATE RH
5. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE
6. REMOVE LUGGAGE COMPARTMENT NO. 1 TRIM HOOK
7. REMOVE REAR SEAT COVER CAP
8. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH
9. REMOVE TIRE PRESSURE WARNING ECU
|
(a) Detach the clamp. |
(b) Disconnect the ECU connector.
(c) Remove the bolt and ECU.
|
|