| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Vehicle Exterior | Section: Sliding Roof/Convertible | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000002LPB00BX |
| Title: SLIDING ROOF / CONVERTIBLE: SLIDING ROOF HOUSING: REMOVAL (2008 LX570) | ||
REMOVAL
1. REMOVE ENGINE ROOM SIDE COVER LH
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
-
w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
3. REMOVE ROOF HEADLINING ASSEMBLY
(a) Remove the roof headlining
.
4. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH
(a) Remove the airbag
.
5. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY RH
HINT:
Use the same procedures described for the LH side.
6. REMOVE REAR NO. 5 ROOF AIR DUCT
(a) Detach the 2 clips and remove the air duct.
7. REMOVE REAR NO. 4 ROOF AIR DUCT
HINT:
Use the same procedures described for the No. 5 roof air duct.
8. REMOVE SLIDING ROOF SIDE GARNISH LH
(a) Detach the 5 claws and remove the side garnish.
9. REMOVE SLIDING ROOF SIDE GARNISH RH
HINT:
Use the same procedures described for the LH side.
10. REMOVE SLIDING ROOF GLASS SUB-ASSEMBLY
(a) Using a T25 "TORX" driver, remove the 4 screws and glass.
11. REMOVE SLIDING ROOF WEATHERSTRIP
(a) Remove the sliding roof weatherstrip.
12. REMOVE SLIDING ROOF HOUSING SUB-ASSEMBLY
(a) Disconnect the 4 sliding roof drain hoses.
(b) Remove the 8 bolts, 8 nuts and housing.
|
|