HINT:

1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY

(a) Pass the cable into the engine room.

(b) Pass the rear side of the cable through the grommet until the cable stopper is attached to the grommet.

(c) Pass the front side of the cable through the upper radiator support.

(d) Connect the clamps shown in the illustration.

2. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

(a) Connect the hood lock control cable and attach the 2 claws to install the hood lock lever.

3. INSTALL FRONT FENDER MAIN SEAL LH

(a) Attach the 3 clips to install the fender main seal.

4. INSTALL HOOD LOCK ASSEMBLY

(a) Apply MP grease to the sliding areas of the lock.

(b) Connect the hood lock control cable.

(c) Install the hood lock.

(d) Install the 2 bolts and nut. Torque: 5.5 N·m (56 kgf·cm, 49 in·lbf)

(e) Connect the connector.

5. INSTALL HOOD LOCK NUT CAP

(a) Install a new hood lock nut cap.

6. INSTALL HOOD LOCK CONTROL CABLE COVER

(a) Attach the claw to install the cable cover.

(b) Install the 3 screws.

9. ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)