Home › Engine/Hybrid System › Starting › 3UR-FE STARTING: STARTER
Last Modified: 11-27-2007 1.6 A
Service Category: Engine/Hybrid System Section: Starting
Model Year: 2008 Model: LX570 Doc ID: RM000002MDN00DX
Title: 3UR-FE STARTING: STARTER: REMOVAL (2008 LX570)

REMOVAL

1. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH

(a) Remove the exhaust manifold RH 3UR-FE INTAKE / EXHAUST: EXHAUST MANIFOLD: REMOVAL (2008 LX570) .

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

  • w/ Navigation System:

    After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

3. REMOVE STARTER COVER

(a) Remove the 3 bolts and starter cover.

4. REMOVE STARTER ASSEMBLY

(a) Disconnect the starter connector.

(b) Remove the nut and disconnect the starter wire.

(c) Remove the 2 bolts and starter.

(d) Remove the flywheel housing side cover.