SUPPLEMENTAL RESTRAINT SYSTEMS: KNEE AIRBAG ASSEMBLY (for Front Passenger Side): REMOVAL (2008 LX570)

Home › Vehicle Interior › Supplemental Restraint Systems › KNEE AIRBAG ASSEMBLY (for Front Passenger Side)

Last Modified: 11-27-2007		1.6 A
Service Category: Vehicle Interior	Section: Supplemental Restraint Systems
Model Year: 2008	Model: LX570	Doc ID: RM000002OEW007X
Title: SUPPLEMENTAL RESTRAINT SYSTEMS: KNEE AIRBAG ASSEMBLY (for Front Passenger Side): REMOVAL (2008 LX570)

REMOVAL

1. REMOVE ENGINE ROOM SIDE COVER LH

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

w/ Navigation System:

After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

When disconnecting the cable, some systems need to be initialized after the cable is reconnected .

3. REMOVE FRONT DOOR SCUFF PLATE RH

4. REMOVE COWL SIDE TRIM BOARD RH

5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

6. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

7. REMOVE INNER NO. 1 INSTRUMENT PANEL BRACKET COVER RH

8. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY

(a) Remove the 4 bolts.

(b) Detach the 4 claws and remove the front passenger side knee airbag.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.