Home › Engine/Hybrid System › Engine Control › 3UR-FE ENGINE CONTROL: ENGINE COOLANT TEMPERATURE SENSOR
Last Modified: 11-27-2007 1.6 A
Service Category: Engine/Hybrid System Section: Engine Control
Model Year: 2008 Model: LX570 Doc ID: RM000002PQG00GX
Title: 3UR-FE ENGINE CONTROL: ENGINE COOLANT TEMPERATURE SENSOR: REMOVAL (2008 LX570)

REMOVAL

1. REMOVE ENGINE ROOM SIDE COVER LH EXTERIOR PANELS / TRIM: RADIATOR GRILLE: REMOVAL (2008 LX570)+

2. REMOVE ENGINE ROOM SIDE COVER RH EXTERIOR PANELS / TRIM: RADIATOR GRILLE: REMOVAL (2008 LX570)+

3. REMOVE UPPER RADIATOR SUPPORT SEAL EXTERIOR PANELS / TRIM: RADIATOR GRILLE: REMOVAL (2008 LX570)+

4. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH EXTERIOR PANELS / TRIM: FRONT BUMPER: REMOVAL (2008 LX570)+

5. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH EXTERIOR PANELS / TRIM: FRONT BUMPER: REMOVAL (2008 LX570)+

6. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY 3UR-FE INTAKE / EXHAUST: EXHAUST MANIFOLD: REMOVAL (2008 LX570)+

7. DRAIN ENGINE COOLANT 3UR-FE COOLING: COOLANT: REPLACEMENT (2008 LX570)+

8. REMOVE V-BANK COVER SUB-ASSEMBLY 3UR-FE ENGINE MECHANICAL: ENGINE ASSEMBLY: REMOVAL (2008 LX570)+

9. REMOVE ENGINE COOLANT TEMPERATURE SENSOR



(a) Disconnect the sensor connector.

(b) Using a 19 mm deep socket wrench, remove the sensor.

(c) Remove the gasket from the sensor.