THEFT DETERRENT / KEYLESS ENTRY: ELECTRICAL KEY OSCILLATOR (for Rear Floor): REMOVAL (2008 LX570)

Home › Vehicle Interior › Theft Deterrent/Keyless Entry › ELECTRICAL KEY OSCILLATOR (for Rear Floor)

Last Modified: 11-27-2007		1.6 A
Service Category: Vehicle Interior	Section: Theft Deterrent/Keyless Entry
Model Year: 2008	Model: LX570	Doc ID: RM000002QFV00CX
Title: THEFT DETERRENT / KEYLESS ENTRY: ELECTRICAL KEY OSCILLATOR (for Rear Floor): REMOVAL (2008 LX570)

REMOVAL

1. REMOVE ENGINE ROOM SIDE COVER LH

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

w/ Navigation System:

After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

When disconnecting the cable, some systems need to be initialized after the cable is reconnected .

3. REMOVE REAR NO. 1 SEAT ASSEMBLY LH

(a) Remove the rear No. 1 seat assembly LH .

4. REMOVE REAR NO. 1 SEAT ASSEMBLY RH

(a) Remove the rear No. 1 seat assembly RH .

5. REMOVE REAR NO. 2 SEAT ASSEMBLY

(a) Remove the rear No. 2 seat assembly .

6. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH

(a) Remove the front quarter trim panel assembly LH .

7. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH

(a) Remove the front quarter trim panel assembly RH .

8. REMOVE REAR NO. 1 SEAT PROTECTOR

9. REMOVE REAR NO. 2 SEAT PROTECTOR

10. REMOVE INDOOR ELECTRICAL KEY OSCILLATOR

(a) Fold back the front floor carpet assembly.

(b) Disconnect the connector.