Home › Vehicle Exterior › Window/Glass › POWER WINDOW REGULATOR MOTOR (for Front Door)
Last Modified: 11-27-2007 1.6 A
Service Category: Vehicle Exterior Section: Window/Glass
Model Year: 2008 Model: LX570 Doc ID: RM000002STV00GX
Title: WINDOW / GLASS: POWER WINDOW REGULATOR MOTOR (for Front Door): INSTALLATION (2008 LX570)

INSTALLATION

HINT:

1. INSTALL FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

(a) Apply MP grease to the sliding and rotating areas of the regulator motor.

(b) Using a T25 "TORX" driver, install the motor with the 3 screws.

Torque: 5.4 N·m (55 kgf·cm, 48 in·lbf)

HINT:

A new front window regulator uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.

2. INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY DOOR / HATCH: FRONT DOOR: REASSEMBLY (2008 LX570)+

3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY DOOR / HATCH: FRONT DOOR: REASSEMBLY (2008 LX570)+

4. INSTALL FRONT DOOR SERVICE HOLE COVER DOOR / HATCH: FRONT DOOR: REASSEMBLY (2008 LX570)+

5. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY AUDIO / VIDEO: FRONT DOOR SPEAKER: INSTALLATION (2008 LX570)+

6. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY DOOR / HATCH: FRONT DOOR: REASSEMBLY (2008 LX570)+

7. INSTALL FRONT UPPER ARMREST BASE PANEL DOOR / HATCH: FRONT DOOR: REASSEMBLY (2008 LX570)+

8. INSTALL FRONT DOOR INSIDE HANDLE BEZEL DOOR / HATCH: FRONT DOOR: REASSEMBLY (2008 LX570)+

9. FRONT LOWER DOOR FRAME BRACKET GARNISH DOOR / HATCH: FRONT DOOR: REASSEMBLY (2008 LX570)+

10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION (2008 LX570) .