SUPPLEMENTAL RESTRAINT SYSTEMS: SIDE AIRBAG SENSOR: REMOVAL (2008 LX570)

Home › Vehicle Interior › Supplemental Restraint Systems › SIDE AIRBAG SENSOR

Last Modified: 11-27-2007		1.6 A
Service Category: Vehicle Interior	Section: Supplemental Restraint Systems
Model Year: 2008	Model: LX570	Doc ID: RM000002ZQJ00AX
Title: SUPPLEMENTAL RESTRAINT SYSTEMS: SIDE AIRBAG SENSOR: REMOVAL (2008 LX570)

REMOVAL

1. REMOVE ENGINE ROOM SIDE COVER LH

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

w/ Navigation System:

After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

When disconnecting the cable, some systems need to be initialized after the cable is reconnected .

3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

4. REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH

5. REMOVE FRONT ARMREST UPPER BASE PANEL LH

6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

7. REMOVE SIDE AIRBAG SENSOR

(a) Disconnect the connector.

(b) Remove the bolt and side airbag sensor.