| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Vehicle Interior | Section: Theft Deterrent/Keyless Entry | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000003117007X |
| Title: THEFT DETERRENT / KEYLESS ENTRY: ENGINE HOOD COURTESY SWITCH: INSTALLATION (2008 LX570) | ||
INSTALLATION
1. INSTALL HOOD LOCK ASSEMBLY
|
(a) Apply MP grease to the sliding areas of the lock. |
|
(b) Connect the hood lock control cable. |
|
(c) Connect the connector. |
(d) Install the hood lock with the 2 bolts and nut.
Torque: 5.5 N·m (57 kgf·cm, 49 in·lbf)
(e) Install a new hood lock nut cap.
2. INSTALL HOOD LOCK CONTROL CABLE COVER
(a) Attach the claw to install the cover.
(b) Install the 3 screws.
3. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)
4. INSTALL RADIATOR GRILLE ASSEMBLY
5. INSTALL UPPER RADIATOR SUPPORT SEAL
6. INSTALL ENGINE ROOM SIDE COVER RH
7. INSTALL ENGINE ROOM SIDE COVER LH
8. ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)
(a) Adjust millimeter wave radar sensor assembly
.
|
|