| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Vehicle Exterior | Section: Exterior Panels/Trim | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM0000038KM002X |
| Title: EXTERIOR PANELS / TRIM: FRONT DOOR BELT MOULDING: REMOVAL (2008 LX570) | ||
REMOVAL
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
1. REMOVE ENGINE ROOM SIDE COVER LH
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
-
w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
3. REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH LH
4. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH
5. REMOVE FRONT UPPER ARMREST BASE PANEL LH
6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
7. REMOVE FRONT DOOR PANEL CUSHION
8. REMOVE DOOR TRIM COVER LH
9. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH
10. REMOVE FRONT DOOR SERVICE HOLE COVER LH
11. REMOVE FRONT INNER DOOR GLASS WEATHERSTRIP LH
12. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH
13. REMOVE FRONT DOOR GLASS RUN LH
14. REMOVE FRONT DOOR BELT MOULDING ASSEMBLY LH
(a) Put protective tape around the belt moulding.
|
(b) Detach the claw and remove the belt moulding. |
|
|