Home › Vehicle Exterior › Exterior Panels/Trim › REAR DOOR BELT MOULDING
Last Modified: 11-27-2007 1.6 A
Service Category: Vehicle Exterior Section: Exterior Panels/Trim
Model Year: 2008 Model: LX570 Doc ID: RM0000038KN002X
Title: EXTERIOR PANELS / TRIM: REAR DOOR BELT MOULDING: INSTALLATION (2008 LX570)

INSTALLATION

HINT:

  • Use the same procedures for the RH side and LH side.
  • The procedures listed below are for the LH side.

1. INSTALL REAR DOOR BELT MOULDING ASSEMBLY LH



(a) Attach the claw to install the belt moulding.

2. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH DOOR / HATCH: REAR DOOR: REASSEMBLY (2008 LX570)+

3. INSTALL REAR DOOR QUARTER WINDOW GLASS LH DOOR / HATCH: REAR DOOR: REASSEMBLY (2008 LX570)+

4. INSTALL REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH DOOR / HATCH: REAR DOOR: REASSEMBLY (2008 LX570)+

5. INSTALL REAR DOOR GLASS RUN LH DOOR / HATCH: REAR DOOR: REASSEMBLY (2008 LX570)+

6. INSTALL REAR DOOR SERVICE HOLE COVER LH DOOR / HATCH: REAR DOOR: REASSEMBLY (2008 LX570)+

7. INSTALL REAR INNER DOOR GLASS WEATHERSTRIP LH DOOR / HATCH: REAR DOOR: REASSEMBLY (2008 LX570)+

8. INSTALL REAR DOOR TRIM COVER LH DOOR / HATCH: REAR DOOR: REASSEMBLY (2008 LX570)+

9. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH DOOR / HATCH: REAR DOOR: REASSEMBLY (2008 LX570)+

10. INSTALL REAR UPPER DOOR ARMREST BASE PANEL LH DOOR / HATCH: REAR DOOR: REASSEMBLY (2008 LX570)+

11. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH DOOR / HATCH: REAR DOOR: REASSEMBLY (2008 LX570)+

12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION (2008 LX570) .

13. INSTALL ENGINE ROOM SIDE COVER LH EXTERIOR PANELS / TRIM: RADIATOR GRILLE: INSTALLATION (2008 LX570)+