| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Vehicle Exterior | Section: Exterior Panels/Trim | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM0000038KP002X |
| Title: EXTERIOR PANELS / TRIM: REAR DOOR BELT MOULDING: REMOVAL (2008 LX570) | ||
REMOVAL
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
1. REMOVE ENGINE ROOM SIDE COVER LH
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
-
w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
3. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH
4. REMOVE REAR UPPER DOOR ARMREST BASE PANEL LH
5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
6. REMOVE REAR DOOR TRIM COVER LH
7. REMOVE REAR INNER DOOR GLASS WEATHERSTRIP LH
8. REMOVE REAR DOOR SERVICE HOLE COVER LH
9. REMOVE REAR DOOR GLASS RUN LH
10. REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH
11. REMOVE REAR DOOR QUARTER WINDOW GLASS LH
12. REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH
13. REMOVE REAR DOOR BELT MOULDING ASSEMBLY LH
(a) Put protective tape around the belt moulding.
|
(b) Detach the claw and remove the belt moulding. |
|
|