SUPPLEMENTAL RESTRAINT SYSTEMS: REAR FLOOR AIRBAG SENSOR: INSTALLATION (2008 LX570)

Home › Vehicle Interior › Supplemental Restraint Systems › REAR FLOOR AIRBAG SENSOR

Last Modified: 11-27-2007		1.6 A
Service Category: Vehicle Interior	Section: Supplemental Restraint Systems
Model Year: 2008	Model: LX570	Doc ID: RM0000038MU002X
Title: SUPPLEMENTAL RESTRAINT SYSTEMS: REAR FLOOR AIRBAG SENSOR: INSTALLATION (2008 LX570)

INSTALLATION

1. INSTALL REAR FLOOR AIRBAG SENSOR

(a) Check that the engine switch is off.

(b) Check that the cable is disconnected from the battery negative (-) terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

w/ Navigation System:

After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

When disconnecting the cable, some systems need to be initialized after the cable is reconnected .

Torque: 9.0 N·m (92 kgf·cm, 80 in·lbf)

NOTICE:

If the rear floor airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

When installing the rear floor airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

(d) Check that there is no looseness in the installation parts of the rear floor airbag sensor.

(e) Connect the connector.

(f) Attach the clip and claw to install the cover.

(g) Return the floor carpet to its original position.

2. INSTALL REAR DOOR SCUFF PLATE RH

3. INSTALL REAR DOOR SCUFF PLATE LH

4. INSTALL REAR STEP COVER

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected .

6. INSTALL ENGINE ROOM SIDE COVER LH

7. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light .