| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Vehicle Exterior | Section: Lighting (ext) | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM0000038XM002X |
| Title: LIGHTING (EXT): STOP LIGHT SWITCH: INSTALLATION (2008 LX570) | ||
INSTALLATION
1. INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER
(a) Install a new stop light switch mounting adjuster to the pedal support.
2. INSTALL STOP LIGHT SWITCH
|
(a) Install the stop light switch to the adjuster until it slightly touches the brake pedal. NOTICE:
Do not depress the brake pedal. |
|
(b) Turn the stop light switch quarter in clockwise to install it. NOTICE:
Do not depress the brake pedal. Torque: 1.5 N·m (15 kgf·cm, 13 in·lbf) NOTICE:
|
(c) Check the stop light switch clearance.
Stop light switch clearance:
1.5 to 2.5 mm (0.0590 to 0.0984 in.)
(d) Connect the wire harness clamp to the pedal support.
(e) Connect the connector to the stop light switch.
3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
|
|