Home › Vehicle Interior › Seat › FRONT SEAT ASSEMBLY
Last Modified: 11-27-2007 1.6 A
Service Category: Vehicle Interior Section: Seat
Model Year: 2008 Model: LX570 Doc ID: RM00000390Q003X
Title: SEAT: FRONT SEAT ASSEMBLY: INSTALLATION (2008 LX570)

INSTALLATION

HINT:

  • Use the same procedures for the LH side and RH side.
  • The procedures listed below are for the LH side.

1. INSTALL FRONT SEAT ASSEMBLY LH

(a) Place the front seat assembly in the cabin.

NOTICE:

Be careful not to damage the vehicle body.

(b) Connect the seat wire connectors under the seat.

(c) Connect the cable to the negative (-) battery terminal.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION (2008 LX570) .

(d) Temporarily install the front seat assembly with the 4 bolts.

(e) Operate the power seat switch (slide switch) to move the seat to the rearmost position.

(f) Tighten the bolts in the order shown in the illustration.

Torque: 37 N·m (377 kgf·cm, 27 ft·lbf)

(g) Operate the power seat switch (slide switch) to move the seat to the foremost position.

(h) Tighten the bolts in the order shown in the illustration.

Torque: 37 N·m (377 kgf·cm, 27 ft·lbf)

2. INSTALL REAR INNER SEAT TRACK BRACKET COVER LH



(a) Attach the 2 claws to install the cover.

3. INSTALL REAR OUTER SEAT TRACK BRACKET COVER LH



(a) Attach the 2 claws to install the cover.

4. INSTALL FRONT INNER SEAT TRACK BRACKET COVER LH



(a) Attach the 2 claws to install the cover.

5. INSTALL FRONT OUTER SEAT TRACK BRACKET COVER LH



(a) Attach the 2 claws to install the cover.

(b) Reset the Autoaway/Return function setting to the previous condition by changing the customize parameter INTRODUCTION: REPAIR INSTRUCTION: CUSTOMIZE PARAMETERS (2008 LX570) .

6. INSTALL FRONT SEAT HEADREST ASSEMBLY

7. INSTALL ENGINE ROOM SIDE COVER LH EXTERIOR PANELS / TRIM: RADIATOR GRILLE: INSTALLATION (2008 LX570)+

8. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM: DIAGNOSIS SYSTEM (2008 LX570) .

9. INSPECT FRONT SEAT ASSEMBLY

(a) Check the power seat operation SEAT: FRONT POWER SEAT CONTROL SYSTEM: OPERATION CHECK (2008 LX570) .

(b) Check the seat heater operation.

(1) Turn the engine switch on (IG).

(2) Turn the seat heater switch on.

(3) Wait 5 minutes or more and confirm that the seat surface becomes warm.

(c) w/ Climate Control Seat System:

Check the climate seat operation SEAT: CLIMATE CONTROL SEAT SYSTEM: OPERATION CHECK (2008 LX570) .