SEAT BELT: REAR NO. 1 SEAT INNER BELT ASSEMBLY (for RH Side): REMOVAL (2008 LX570)

Home › Vehicle Interior › Seat Belt › REAR NO. 1 SEAT INNER BELT ASSEMBLY (for RH Side)

Last Modified: 11-27-2007		1.6 A
Service Category: Vehicle Interior	Section: Seat Belt
Model Year: 2008	Model: LX570	Doc ID: RM0000039EJ005X
Title: SEAT BELT: REAR NO. 1 SEAT INNER BELT ASSEMBLY (for RH Side): REMOVAL (2008 LX570)

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

w/ Navigation System:

After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

When disconnecting the cable, some systems need to be initialized after the cable is reconnected .

2. REMOVE REAR NO. 1 SEAT ASSEMBLY RH

(a) Remove the rear No. 1 seat assembly .

3. REMOVE REAR NO. 1 SEAT RECLINING COVER LH

4. REMOVE REAR NO. 1 SEAT INNER BELT ASSEMBLY RH

(a) Remove the bolt and belt.