|
Last Modified: 11-27-2007 |
1.6 A |
|
Service Category: Vehicle Interior |
Section: Door Lock |
|
Model Year: 2008 |
Model: LX570 |
Doc ID: RM0000039H0003X |
|
Title: DOOR LOCK: FRONT DOOR LOCK: REMOVAL (2008 LX570) |
REMOVAL
HINT:
-
Use the same procedures for the LH side and RH side.
-
The procedures listed below are for the LH side.
1. REMOVE ENGINE ROOM SIDE COVER LH
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
-
w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
3. REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH LH
4. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH
5. REMOVE FRONT UPPER ARMREST BASE PANEL LH
6. REMOVE COURTESY LIGHT ASSEMBLY
7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
8. REMOVE FRONT DOOR PANEL CUSHION
9. REMOVE DOOR TRIM COVER LH
10. REMOVE FRONT DOOR SERVICE HOLE COVER LH
11. REMOVE FRONT NO. 2 DOOR STIFFENER CUSHION
12. REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH
13. REMOVE FRONT DOOR OUTSIDE HANDLE COVER LH
14. REMOVE FRONT DOOR LOCK ASSEMBLY LH
|
(a) Using a T30 "TORX" wrench, remove the 3 screws and door lock.
NOTICE:
Be careful when removing the screws as the door lock may fall and become damaged.
|
(b) Remove the door lock through the service hole.
15. REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH
16. REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH
|