| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Vehicle Interior | Section: Door Lock | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM0000039H4005X |
| Title: DOOR LOCK: REAR DOOR LOCK: REMOVAL (2008 LX570) | ||
REMOVAL
HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
1. REMOVE ENGINE ROOM SIDE COVER LH
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
-
w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
3. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH
4. REMOVE REAR UPPER DOOR ARMREST BASE PANEL LH
5. REMOVE COURTESY LIGHT ASSEMBLY
6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
7. REMOVE REAR DOOR TRIM COVER LH
8. REMOVE REAR DOOR SERVICE HOLE COVER LH
9. REMOVE REAR DOOR LOCK ASSEMBLY LH
|
(a) Using a T30 "TORX" socket, remove the 3 screws and door lock. NOTICE:
Be careful when removing the screws as the door lock may fall and become damaged. |
10. REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH
11. REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH
|
|