| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Vehicle Interior | Section: Theft Deterrent/Keyless Entry | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM0000039H4006X |
| Title: THEFT DETERRENT / KEYLESS ENTRY: ENTRY LOCK AND UNLOCK SWITCH (for Rear): REMOVAL (2008 LX570) | ||
REMOVAL
HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
1. REMOVE ENGINE ROOM SIDE COVER LH
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
-
w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
3. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH
4. REMOVE REAR UPPER DOOR ARMREST BASE PANEL LH
5. REMOVE COURTESY LIGHT ASSEMBLY
6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
7. REMOVE REAR DOOR TRIM COVER LH
8. REMOVE REAR DOOR SERVICE HOLE COVER LH
9. REMOVE REAR DOOR LOCK ASSEMBLY LH
10. REMOVE REAR DOOR OUTSIDE HANDLE COVER LH
11. REMOVE REAR DOOR OUTSIDE HANDLE ASSEMBLY LH
|
(a) Using a T30 "TORX" wrench, loosen the screw. |
(b) Disconnect the connector.
|
(c) Remove the handle by sliding and pulling it in the direction indicated by the arrows in the illustration. |
|
|