Home › Engine/Hybrid System › Lubrication › 3UR-FE LUBRICATION: OIL LEVEL SENSOR
Last Modified: 11-27-2007 1.6 A
Service Category: Engine/Hybrid System Section: Lubrication
Model Year: 2008 Model: LX570 Doc ID: RM0000039KY001X
Title: 3UR-FE LUBRICATION: OIL LEVEL SENSOR: REMOVAL (2008 LX570)

REMOVAL

1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH EXTERIOR PANELS / TRIM: FRONT BUMPER: REMOVAL (2008 LX570)+

2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH EXTERIOR PANELS / TRIM: FRONT BUMPER: REMOVAL (2008 LX570)+

3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY 3UR-FE INTAKE / EXHAUST: EXHAUST MANIFOLD: REMOVAL (2008 LX570)+

4. REMOVE NO. 2 ENGINE UNDER COVER 3UR-FE INTAKE / EXHAUST: EXHAUST MANIFOLD: REMOVAL (2008 LX570)+

5. DRAIN ENGINE OIL 3UR-FE LUBRICATION: OIL AND OIL FILTER: REPLACEMENT (2008 LX570)+

6. DISCONNECT OIL COOLER PIPE ASSEMBLY

(a) Remove the 2 bolts and disconnect the oil cooler pipe.

7. REMOVE ENGINE OIL LEVEL SENSOR

(a) Disconnect the oil level sensor connector.

(b) Remove the 4 bolts and oil level sensor.

(c) Cut off the gasket as shown in the illustration.

(d) Remove the gasket from the oil level sensor.

HINT:

After cutting away the parts of the gasket shown in the illustration, remove only the outer part of the gasket.