| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Vehicle Interior | Section: Supplemental Restraint Systems | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM0000039P1003X |
| Title: PRE-COLLISION: SEAT BELT CONTROL ECU: INSTALLATION (2008 LX570) | ||
INSTALLATION
1. INSTALL SEAT BELT CONTROL ECU
(a) Install the seat belt control ECU to the certification ECU with the bolt.
Torque: 5.5 N·m (56 kgf·cm, 49 in·lbf)
|
(b) Install the seat belt control ECU together with the certification ECU with the 2 nuts. Torque: 5.5 N·m (56 kgf·cm, 49 in·lbf) |
(c) Connect the connectors.
2. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY
3. INSTALL INSTRUMENT PANEL BOX ASSEMBLY
4. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
5. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
6. INSTALL NO. 1 SWITCH HOLE BASE
7. INSTALL INSTRUMENT SIDE PANEL LH
8. INSTALL INNER NO. 1 INSTRUMENT PANEL BRACKET COVER LH
9. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
11. INSTALL ENGINE ROOM SIDE COVER LH
12. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light
.
|
|