PRE-COLLISION: SEAT BELT CONTROL ECU: REMOVAL (2008 LX570)

Home › Vehicle Interior › Supplemental Restraint Systems › PRE-COLLISION: SEAT BELT CONTROL ECU

Last Modified: 11-27-2007		1.6 A
Service Category: Vehicle Interior	Section: Supplemental Restraint Systems
Model Year: 2008	Model: LX570	Doc ID: RM0000039P3003X
Title: PRE-COLLISION: SEAT BELT CONTROL ECU: REMOVAL (2008 LX570)

REMOVAL

1. REMOVE ENGINE ROOM SIDE COVER LH

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

w/ Navigation System:

After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

When disconnecting the cable, some systems need to be initialized after the cable is reconnected .

3. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

4. REMOVE INNER NO. 1 INSTRUMENT PANEL BRACKET COVER LH

5. REMOVE INSTRUMENT SIDE PANEL LH

6. REMOVE NO. 1 SWITCH HOLE BASE

7. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

8. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

9. REMOVE INSTRUMENT PANEL BOX ASSEMBLY

10. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY

11. REMOVE SEAT BELT CONTROL ECU

(a) Disconnect the connectors.

(b) Remove the 2 nuts and seat belt control ECU together with the certification ECU.