Home › Suspension › Suspension Control System › SUSPENSION CONTROL: DAMPING FORCE CONTROL ACTUATOR (for Rear Side)
Last Modified: 11-27-2007 1.6 G
Service Category: Suspension Section: Suspension Control System
Model Year: 2008 Model: LX570 Doc ID: RM000003A03003X
Title: SUSPENSION CONTROL: DAMPING FORCE CONTROL ACTUATOR (for Rear Side): ON-VEHICLE INSPECTION (2008 LX570)

ON-VEHICLE INSPECTION

1. REMOVE REAR QUARTER PANEL MUDGUARD RH EXTERIOR PANELS / TRIM: MUDGUARD: REMOVAL (2008 LX570)+

2. REMOVE FUEL TANK FILLER PIPE PROTECTOR SUSPENSION CONTROL: ACTIVE HEIGHT CONTROL PUMP AND MOTOR: REMOVAL (2008 LX570)+

3. INSPECT REAR SUSPENSION CONTROL ACCUMULATOR ASSEMBLY LH

NOTICE:

Perform the following after inspecting and adjusting the vehicle height.

(a) With the vehicle empty, start the engine and set the vehicle height to LOW.

(b) Record the reservoir tank fluid level (A).

(c) Set the vehicle height to HIGH.

HINT:

Make sure to check the fluid level approximately 30 seconds after the vehicle height changes to HIGH.

(d) Record the reservoir tank fluid level (B), and check that A minus B is within the specified value.

Specified Value:

A - B = 5 marks or more

If the result is not as specified, replace all suspension control accumulators.