Home › Suspension › Suspension Control System › SUSPENSION CONTROL: HEIGHT CONTROL SENSOR (for Front Side)
Last Modified: 11-27-2007 1.6 N
Service Category: Suspension Section: Suspension Control System
Model Year: 2008 Model: LX570 Doc ID: RM000003A06001X
Title: SUSPENSION CONTROL: HEIGHT CONTROL SENSOR (for Front Side): ADJUSTMENT (2008 LX570)

ADJUSTMENT

1. ADJUST FRONT HEIGHT CONTROL SENSOR LINK SUB-ASSEMBLY

NOTICE:

  • Make adjustments from the link that deviates the most from the specified vehicle height value.
  • When the front and rear are at the same level, make adjustments from the front first.
  • If adjustment cannot be completed through the vehicle height offset calibration, adjust the sensor link using the following procedure.


(a) Loosen the nut and adjust the link installation position by moving the height control sensor link up or down in the long hole of the bracket.

HINT:

When the link is moved 1 mm (0.0394 in.), the vehicle height changes by approximately 2 mm (0.0787 in.).

(b) Tighten the nut of the height control sensor link.

Torque: 5.6 N·m (57 kgf·cm, 50 in·lbf)

2. PERFORM VEHICLE HEIGHT OFFSET CALIBRATION

(a) Perform the vehicle height offset calibration SUSPENSION CONTROL: ACTIVE HEIGHT CONTROL SUSPENSION: INITIALIZATION (2008 LX570) .

3. PERFORM ZERO POINT CALIBRATION OF G SENSOR

(a) Perform the zero point calibration of the G sensor BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: CALIBRATION (2008 LX570) .

4. ADJUST FRONT WHEEL ALIGNMENT

(a) Adjust the front wheel alignment ALIGNMENT / HANDLING DIAGNOSIS: FRONT WHEEL ALIGNMENT: ADJUSTMENT (2008 LX570) .

5. ADJUST HEADLIGHT ASSEMBLY

(a) Adjust the headlight LIGHTING (EXT): HEADLIGHT ASSEMBLY: ADJUSTMENT (2008 LX570) .