Home › Suspension › Suspension Control System › SUSPENSION CONTROL: HEIGHT CONTROL SENSOR (for Front Side)
Last Modified: 11-27-2007 1.6 A
Service Category: Suspension Section: Suspension Control System
Model Year: 2008 Model: LX570 Doc ID: RM000003A0A001X
Title: SUSPENSION CONTROL: HEIGHT CONTROL SENSOR (for Front Side): REMOVAL (2008 LX570)

REMOVAL

HINT:

  • Use the same procedures for the RH side and LH side.
  • The procedures listed below are for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION (2008 LX570) .

2. REMOVE FRONT WHEEL

3. REMOVE FRONT FENDER APRON SEAL FRONT LH 3UR-FE INTAKE / EXHAUST: EXHAUST MANIFOLD: REMOVAL (2008 LX570)+

4. REMOVE FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

(a) Disconnect the connector.

(b) Remove the nut, bolt and sensor.