HEATING / AIR CONDITIONING: AIR CONDITIONING PANEL: REMOVAL (2008 LX570)

Home › Vehicle Interior › Heating/Air Conditioning › AIR CONDITIONING PANEL

Last Modified: 11-27-2007		1.6 A
Service Category: Vehicle Interior	Section: Heating/Air Conditioning
Model Year: 2008	Model: LX570	Doc ID: RM000003B46004X
Title: HEATING / AIR CONDITIONING: AIR CONDITIONING PANEL: REMOVAL (2008 LX570)

REMOVAL

1. REMOVE ENGINE ROOM SIDE COVER LH

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

w/ Navigation System:

After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

When disconnecting the cable, some systems need to be initialized after the cable is reconnected .

3. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

4. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

5. REMOVE INSTRUMENT SIDE PANEL LH

6. REMOVE NO. 1 SWITCH HOLE BASE

7. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

8. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

9. REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

10. REMOVE MULTI-DISPLAY ASSEMBLY WITH BRACKET

(a) Remove the 2 screws and 2 bolts.

(b) Pull the radio receiver to detach the 4 clips on the backside of the display.