| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Vehicle Interior | Section: Heating/Air Conditioning | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000003B9O002X |
| Title: HEATING / AIR CONDITIONING: DUCT TEMPERATURE SENSOR: REMOVAL (2008 LX570) | ||
REMOVAL
1. REMOVE ENGINE ROOM SIDE COVER LH
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
-
w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
3. REMOVE REAR NO. 1 SEAT ASSEMBLY LH
(a) Remove the rear No. 1 seat assembly
.
4. REMOVE REAR NO. 1 SEAT ASSEMBLY RH
(a) Remove the rear No. 1 seat assembly
.
5. REMOVE REAR NO. 2 SEAT ASSEMBLY LH
(a) Remove the rear No. 2 seat assembly
.
6. REMOVE REAR NO. 2 SEAT ASSEMBLY RH
(a) Remove the rear No. 2 seat assembly
.
7. REMOVE REAR STEP COVER
8. REMOVE REAR DOOR SCUFF PLATE LH
9. REMOVE REAR DOOR SCUFF PLATE RH
10. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE
11. REMOVE REAR SEAT COVER CAP (for Semi Power Seat)
12. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH
13. REMOVE REAR SEAT COVER CAP (for Semi Power Seat)
14. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH
15. REMOVE REAR NO. 1 SEAT PROTECTOR
16. REMOVE REAR NO. 2 SEAT PROTECTOR
17. REMOVE FRONT FLOOR CARPET ASSEMBLY
(a) Remove the 2 clips.
(b) Fold back the floor carpet.
HINT:
Fold back the carpet until it is possible to remove the rear No. 6 air duct.
18. REMOVE REAR NO. 6 AIR DUCT
(a) Disconnect the 2 connectors.
(b) Remove the 5 screws and duct.
19. REMOVE DUCT TEMPERATURE SENSOR
(a) Detach the 4 claws and remove the 2 sensors.
|
|