| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Vehicle Interior | Section: Theft Deterrent/Keyless Entry | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000003BIJ001X |
| Title: THEFT DETERRENT / KEYLESS ENTRY: CERTIFICATION ECU: REMOVAL (2008 LX570) | ||
REMOVAL
1. REMOVE ENGINE ROOM SIDE COVER LH
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
-
w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
3. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
4. REMOVE INNER NO. 1 INSTRUMENT PANEL BRACKET COVER LH
5. REMOVE INSTRUMENT SIDE PANEL LH
6. REMOVE NO. 1 SWITCH HOLE BASE
7. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
8. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
9. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY
10. REMOVE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) (w/ Pre-collision System)
|
(a) Disconnect the connectors. |
(b) Remove the 2 nuts and the certification ECU (smart key ECU assembly) with seat belt control ECU.
|
(c) Remove the bolt and ECU. |
11. REMOVE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) (w/o Pre-collision System)
|
(a) Disconnect the connectors. |
(b) Remove the 2 nuts and the certification ECU (smart key ECU assembly) with bracket.
|
(c) Remove the bolt and ECU. |
|
|