Home › Suspension › Rear Suspension › REAR UPPER ARM
Last Modified: 11-27-2007 1.6 A
Service Category: Suspension Section: Rear Suspension
Model Year: 2008 Model: LX570 Doc ID: RM000003BZC003X
Title: REAR SUSPENSION: REAR UPPER ARM: INSTALLATION (2008 LX570)

INSTALLATION

HINT:

1. TEMPORARILY INSTALL REAR UPPER CONTROL ARM ASSEMBLY LH

(a) Temporarily install the rear upper control arm with the 2 bolts, 2 washers and 2 nuts.

2. STABILIZE SUSPENSION REAR SUSPENSION: REAR SHOCK ABSORBER: INSTALLATION (2008 LX570)+

3. TIGHTEN REAR UPPER CONTROL ARM ASSEMBLY LH

(a) Tighten the 2 nuts.

Torque: 150 N·m (1530 kgf·cm, 111 ft·lbf)

NOTICE:

Perform this procedure with all 4 wheels on the ground.

4. INSTALL UPPER ARM BUSH HEAT INSULATOR

(a) Install the upper arm bush heat insulator with the bolt.

Torque: 18 N·m (184 kgf·cm, 13 ft·lbf)

5. CONNECT SPEED SENSOR WIRE HARNESS

(a) Connect the speed sensor wire harness with the bolt.

Torque: 13 N·m (127 kgf·cm, 9 ft·lbf)

6. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH SUSPENSION CONTROL: HEIGHT CONTROL SENSOR (for Rear Side): INSTALLATION (2008 LX570)+

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION (2008 LX570) .

8. PERFORM VEHICLE OFF SET CALIBRATION

(a) Perform the vehicle off set calibration SUSPENSION CONTROL: HEIGHT CONTROL SENSOR (for Rear Side): INSTALLATION (2008 LX570)+ .

9. ADJUST REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH SUSPENSION CONTROL: HEIGHT CONTROL SENSOR (for Rear Side): ADJUSTMENT (2008 LX570)+

10. ADJUST HEADLIGHT ASSEMBLY

(a) Adjust the headlight assembly LIGHTING (EXT): HEADLIGHT ASSEMBLY: ADJUSTMENT (2008 LX570) .