| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Brake | Section: Brake Control/Dynamic Control System | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000003C4A003X |
| Title: BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: CRAWL SWITCH: REMOVAL (2008 LX570) | ||
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
-
w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
2. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
3. REMOVE INNER NO. 1 INSTRUMENT PANEL BRACKET COVER LH
4. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH
5. REMOVE INNER NO. 1 INSTRUMENT PANEL BRACKET COVER RH
6. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
7. REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
8. REMOVE PARKING BRAKE HOLE COVER
9. REMOVE CONSOLE CUP HOLDER BOX SUB-ASSEMBLY
10. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
11. REMOVE LOWER POSITION INDICATOR HOUSING
12. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY (CRAWL SWITCH)
|
(a) Disconnect the connector. |
(b) Remove the 5 screws and integration control and panel from the position indicator housing.
|
|