| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Steering | Section: Steering Column | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000003DZD001X |
| Title: VARIABLE GEAR RATIO STEERING: STEERING CONTROL ECU: REMOVAL (2008 LX570) | ||
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
w/ Navigation System:
NOTICE:
After the engine switch is turned off, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the engine switch off, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
2. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
3. REMOVE INNER NO. 1 INSTRUMENT PANEL BRACKET COVER LH
4. REMOVE INSTRUMENT SIDE PANEL LH
5. REMOVE FRONT DOOR SCUFF PLATE LH
6. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
7. REMOVE COWL SIDE TRIM BOARD LH
8. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
9. REMOVE NO. 1 SWITCH HOLE BASE
10. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY
11. REMOVE INSTRUMENT PANEL BOX ASSEMBLY
12. REMOVE STEERING CONTROL ECU WITH JUNCTION BLOCK
(a) Rear Side:
(1) Disconnect the 7 connectors.
(2) Detach the 2 clamps.
(3) Remove the bolt and 2 nuts.
(b) Front Side:
(1) Disconnect the 5 connectors.
(c) Remove the ECU with junction block.
13. REMOVE STEERING CONTROL ECU
|
(a) Remove the bolt, nut and ECU from the junction block. |
|
|